Equalizer apo not working5/4/2023 ![]() In these cases you can set the specific audio device from the Peace devices list before saving it to the Configuration list as shown in the next chapter. no or another equalization for the microphone as your equalization is also applied on every input device like a microphone.a (slightly) different equalization for each audio device.But there are circumstances in which this is wrong. That equalization is there to correct the sound for the device you selected. Once you have created an equalization with the sliders, it usually doesn't matter which audio device is currently selected. This is taken from Peace help section Selecting a device.īy default every sound manipulation like an equalization is done on every available audio device, input and output. I understand your case might be different maybe, just want to make sure we are talking about the same thing, I had a similar issue, I followed the instructions here and on the Automation page, it worked for me. blocks) in EQ APO to force it to capture and play the music stream from the default input (in my case is the external soundcard's input) before to apply its filters in order to make it works as stand alone application without opening every time VLC Media Player and play the incoming music stream.Ĭlick to expand.I was referring to this section of the help. ![]() In conclusion: I need the sequence of instructions (e.g. in this way Eq APO receives the input stream and output the EQ'ed stream to output. The only way I found is working so far is to open a player like VLC Media Player -> open the capture device "soundcard input" -> play it. I'm sure the PC input is capturing the music stream (if I open REW and check the input levels the VU-meter moves and follow the music volume) but I don't know which is the way (that is: the instructions sequence) to tell EQ APO: "Capture the music stream from analog / digital input -> apply filters -> playback the stream to analog / digital output". from CD player or other sources) and I need to playback it (after filters correction) to the soundcard output, no way to listen anything. The problem arises when I try to use it capturing music from the soundcard input (e.g. if I change the attenuation of a preamplifier block). Same thing if I reproduce music from the PC (when EQ APO is switched ON it applies correctly its filters and I can clearly listen to its intervention, e.g. I'm playing with Equalizer APO to implement a free DSP under Windows for room correction (just for test purposes) and I have the problem I will try to explain below.ĮQ APO works fine and is correctly installed on my PC (I already read all the troubleshooting posts), in fact if I loopback the output to input (tried with both analog out -> in and with TOSLINK out -> in) of my external soundcard and I measure the frequency response sweeping with REW I can clearly see its intervention when switched ON (and it works as supposed to do). Second post here, and beg your pardon in advance if this argument has already been discussed (but I found nothing about the solution I need).
0 Comments
Leave a Reply. |